Malše river
The Malše is a European river flowing through Czech Republic. As of 2026-10-16, the Malše was flowing at about 0.32 m³/s at the Pořešín gauge.
- Canonical name
- Malše
- Countries
- Czech Republic
- Maximum upstream drainage area
- 1,017 km²
- Mapped river length
- 29.4 km
- Gauging stations
- 4
- Latest measured discharge
- 0.32 m³/s (Pořešín, 2026-10-16)
Gauging stations on the Malše
The following 4 gauging stations report discharge for the Malše, ordered downstream (largest catchment first). Discharge is in cubic metres per second (m³/s).
| Station | Country | Discharge (m³/s) | Historical Comparison | Observed | Measurement | Data quality | Provider | Lat, Lon | Source |
|---|---|---|---|---|---|---|---|---|---|
| Pořešín | Czech Republic | 0.32 | Much below normal83% below the historic median | instantaneous | CHMI operational data | Czech Hydrometeorological Institute | 48.783, 14.518 | source | |
| Římov | Czech Republic | 0.449 | Much below normal65% below the historic median | instantaneous | CHMI operational data | Czech Hydrometeorological Institute | 48.863, 14.497 | source | |
| Pašinovice | Czech Republic | 0.192 | Much below normal89% below the historic median | instantaneous | CHMI operational data | Czech Hydrometeorological Institute | 48.878, 14.526 | source | |
| Roudné | Czech Republic | 0.655 | Much below normal82% below the historic median | instantaneous | CHMI operational data | Czech Hydrometeorological Institute | 48.935, 14.49 | source |
Related rivers
Data, sources & timestamps
Geometry is the HydroRIVERS network (HydroSHEDS): European reaches with at least 500 km² of upstream catchment, merged into chains between confluences. Flow direction comes from the network itself; river names are the canonical English label joined from provider metadata and Natural Earth, with local-language aliases retained.
Discharge is normalised observed streamflow from official national hydrology providers, measured where a gauge sits on the river and interpolated between gauges. Pale/estimated values are derived from drainage area × the local specific discharge of nearby gauges and are never presented as measurements.